Field treatment of all end cuts and borings, including plumbing and electrical holes, is required on all lumber and timbers over 2” in thickness. Field treatment shall be either a 2% solution (copper metal basis) of Copper Naphthenate or a 10% solution of DOT, or another end coat preservative approved by Koppers.
Use industry accepted good construction practices for the construction of all wood member assemblies.
Construction shall meet or exceed state and local building codes and standards.
Comply with local, state, and federal safety regulations when installing framing and sheathing.
Job Site Storage and Handling
As with untreated wood, it is necessary to keep Advance Guard® Borate Pressure Treated Wood products dry by covering the material or storing the materials under shelter and elevating the material above the ground to allow for air circulation.
Sheathing should be covered as soon as practical after installation. If wetted during initial construction, allow materials to properly dry before permanently enclosing with felt, wallboard, etc.
After working with the wood, and before eating, drinking, and use of tobacco products, wash exposed areas thoroughly.