Our Products

MicroPro^® Important Information

The following precautions should be taken both when handling the preserved wood and in determining where to use and dispose of it. Many of these precautions also apply to untreated wood and other building materials.

Download MicroPro^® Safety Data Sheet (SDS).

• Do not burn preserved wood.
• Wear NIOSH N95 dust mask and goggles when cutting or sanding wood.
• Wear gloves when working with wood.
• Some preservative may migrate from the treated wood into soil/water or may dislodge from the treated wood surface upon contact with skin. Wash exposed skin areas thoroughly.
• All sawdust and construction debris should be cleaned up and disposed of after construction.
• Wash work clothes separately from other household clothing before reuse.
• Preserved wood should not be used where it may come into direct or indirect contact with drinking water, except for uses involving incidental contact such as fresh water docks and bridges.
• Do not use preserved wood under circumstances where the preservative may become a component of food, animal feed, or beehives.
• Do not use preserved wood as mulch.
• Only preserved wood that is visibly clean and free of surface residue should be used.
• If the wood is to be used in an interior application and becomes wet during construction, it should be allowed to dry before being covered or enclosed.
• Disposal Recommendations: Preserved wood may be disposed of in landfills or burned in commercial or industrial incinerators or boilers in accordance with federal, state, and local regulations.
• If you desire to apply a paint, stain, clear water repellent, or other finish to your preservative treated wood, we recommend following the manufacturer’s instructions and label of the finishing product. Before you start, we recommend you apply the finishing product to a small exposed test area before finishing the entire project to insure it provides the intended result before proceeding.
• Projects should be designed and installed in accordance with federal, state, and local building codes and ordinances governing construction in your area and in accordance with the National Design Specifications (NDS) and the Wood Handbook.
• Mold growth can and does occur on the surface of many products, including untreated and treated wood, during prolonged surface exposure to excessive moisture conditions. To remove mold from the treated wood surface, wood should be allowed to dry. Typically, mild soap and water can be used to remove remaining surface mold. For more information visit www.epa.gov .
• Use fasteners and hardware that are in compliance with the manufacturer’s recommendations and the building codes for their intended use. When using aluminum products in conjunction with MicroPro^® treated wood, refer to the Fastener and Hardware Information page for additional information.
• Use wood preservatives safely. Always read the label and product information before use.